Hanging Bicycle Wall Mount
Description
This is a re-make from other ideas on Thingiverse. I like modeling and so wanted to model my own. I did change the way the bike is connected to the wall. Some of the other models use the pedal, but with smaller kids around I wanted something a little more secure. I am going to use a small ball end bungie to wrap around the frame and then attach to the frame anchor. The Frame Anchor can be printed in two orientations. I tried both ways and neither seemed stronger than the other. I printed them pretty beefy because over-engineering is better than under-engineering. The Wheel Rest is designed for a 700C x 32 wheel and tire and so should accommodate other sizes. I may upload other sizes just to test my parametric design skills. The mounting holes are for #8 ( .16 inch ) screws that mate with drywall anchors. Print Settings: <b>Frame Anchor:</b> Resolution: .2 Infill: 90% Perimeters: 6 Supports: none Brim: none <b>Wheel Rest:</b> Resolution: .2 Infill: 20% Perimeters: 6 Supports: none Brim: none I printed them in a cheap white PLA. <b>Inspirational Things:</b> https://www.thingiverse.com/thing:3199106 https://www.thingiverse.com/thing:2161841 https://www.thingiverse.com/thing:2467730 https://www.thingiverse.com/thing:3072975 https://www.thingiverse.com/thing:2879289 https://www.thingiverse.com/thing:2996115
Statistics
Likes
69
Downloads
0