RC Hatch Latch
Description
This is the little latch I use to replace hatch magnets in models that need to have them removed. They are designed to have a piece of 1.75mm filament as the axis pin. Snip off a small length and then heat the end over a flame then mushroom it out, then cut to length. The other part in this design is a small holder for the pin that can be mounted into the foam to stop the pin moving and loosening over time. You can see the full build of the model here - https://www.youtube.com/playlist?list=PLYsWjANuAm4rDDJ3VmMzTFsQvhWkRrzsV Happy flying!
Statistics
Likes
17
Downloads
0