PCB cable cover and fan housing for Geeetech Pro B
Description
The PCB cabling harness on the Geeetech Pro B is very messy. Also the fan is very inefficient blowing across the PCB. Therefore I created a cover that "clips" behind the PCB i.e. it uses the PCB to hold itself against the back strut. I also took advantage of a hole in the vertical strut - where you can push standard geeetech bolt (3mm) through to hold it in place. The fan I used was not the standard Geeetech one, from a few posts I read, if you can cool the PCB more - you get better prints - so I bought a slightly bigger fan with 50mm centres (Fan DF1206BM) If you want to use a different fan, contact me and I can happily modify the bolt hole centres and hole size.
Statistics
Likes
3
Downloads
0