Recessed lens board 12mm Copal 0 Linhof/Wista style
Description
Recessed Linhof/Wista style lens board (12mm) for wide angle lenses with Copal 0 size shutters. Please note that I am using a slightly simplified layout instead of the original Linhof/Wista layout with notches and so on. You will need a wire trigger with a short connector (typically non-rotatable connectors) - standard size wire triggers with rotatable connectors won't fit. (Tested with an Intrepid 4x5" Mk.4 and a Rodenstock Grandagon 90mm f6.8 in Copal 0 shutter) Update 2019-06-11: Although I initially printed this lens board with PLA (and also actively using it) I do not fully recommend using PLA for lens boards any longer. This is due to the fact that PLA is getting soft at temperatures over 45-60°C (depending on the make/brand of your PLA). So you may end up with malformed parts when leaving them too long in the summer sun... If you are aware of this, then just take precautions, otherwise It's better to use ABS or PETG.
Statistics
Likes
14
Downloads
0