Twin headshell box
Description
So here it is, a remix of the nice headshell case. The design was completely remodeled in Fusion360 so now I can do any changes on it quickly :) It's outer dimensions remain the same, inside I changed these: - lowered the shell holders by 3.5mm - shortened them by 2mm so it's easier to insert longer shells - increased the distance between them by 1mm - changed the retaining blocks in the upper lid, made them lower and a bit wider to follow the changes made on the shell holders - the cut under the latch was unnecessarily large, made it smaller (smaller through-print effect on the outer side as well!) - changed the pattern on the upper lid where one opens the case - applied fillet to ALL inside edges (some were missing in the original design) and changed to 1mm instead of 2mm which looked too much for me - incorporated a little holder for a 45rpm puck - under one of the holders I integrated a 52mm overhang gauge (for Technics players) I think that's all. Hinge has the same dimensions and tolerances as the original design, so it should print without issues. Now that I have the box model, I can go for the next version: box for my T4P cartridges :) Stay tuned! :)
Statistics
Likes
16
Downloads
0