Goon RDA Cover with splash guard
Description
<b>Edit: I completely re-designed the splash guard so that it is more geometrically uniform and so that it only occupies the mouthpiece. It works perfectly. Also, you can print this without any supports if you use PLA at around 195 degrees. the center post will pop right out after printing with some needle-nose pliers. Just grab it, twist and pull, then it's ready to go.</b> This is a complete RDA cover for the Goon RDA (although I'm sure it will fit others). Inside, I created a stepped group of triangles that start in the middle of the tank and go all the way to the top. They are offset and spaced so that there is plenty of airflow. It is also slightly wider than the original tank cover to accommodate slightly larger coils. After printing, use pliers to grab the center post support, twist it then pull, it should snap right off. It was necessary to have it there to support the splash guard. It fits nice and snug. I printed it on a Flashforge Finder at .1mm per slice for a clean look. I posted different versions, one that is plain, one with the Goon logo on it, one with a skull and one with the Foo Fighters logo (my favorite band :-)
Statistics
Likes
6
Downloads
0