HEVO Hypercube Evolution Idler/Pulley Mount for 10mm or 12mm Rod - Rod Slide in
Description
This is a remix of the great work done by Xcion ( original: https://www.thingiverse.com/thing:2830266 ) that allows the Y axis rod to be slid in from the side. My rods are the exact length of the gap between the extrusions so before this mod I would have to remove either this mount or the motor mount to get the rod installed. This makes life much easier for me and allows me to quickly swap out bearings / bushing on my Y axis to test different setups. Make sure to visit the original thing to get the alignment tool or if you need other sizes ( rod or bearing hole )
Statistics
Likes
19
Downloads
0