Hugo Wifi remote case
Description
Official 3D case for Hugo Wifi remote, get yours on Tindie: https://www.tindie.com/products/mcer12/hugo-esp8266-4-button-wifi-remote/ Check out github repository: https://github.com/mcer12/Hugo-ESP8266 There are 3 versions of the top cover. The original I/O one, one with shapes and one clean with no icons for easy remixing, enjoy! And if you like your print, share a photo :) *EDIT:* Added stl variants that are 0.2mm larger on the sides in case the standard enclosure doesn't fit *EDIT2:* Added a version with holes for 3 magnets for stronger hold, recommended! *EDIT3:* Added new cover with dots. - print without supports - requires 4 8x1mm neodymium magnets - requires double sided 3M tape for wall mounting Print settings for best results (cura): - line width: 0.5mm - wall line count: 3 - 100% infill for top+bottom cover, 20% for wall mount - ideally everything should snap together very tight and there should be no play. Otherwise try to increase extrusion rate by 3-5%
Statistics
Likes
22
Downloads
0