Delonghi kg79 Open Container
Description
Important Update (06 May 2020): ------------------------------------------------------------ I designed a better version. The name of the STL file is delonghi_kg79_container_NEW_VERSION.stl. (It is the one printed with the orange filament whereas the old one was printed with silver gray filament.) Improvements: 1- I removed the thin pillars and filled the walls because they were breaking easily. 2- I also removed the bottom row so that larger cups can fit inside. 3- I removed the empty space toward the top of the container for easier printing. It did not serve any purpose anyways. I recommend you to print the new version. However I will also keep the older version for reference. You should use supports (touching only build plate). 0.3mm layer height and 20% infill works fine. ------------------------------------------------------------ The original container is not really practical for a quick grinding. I made this so that you can put a small cup or the original filter underneath the grinder and grind it directly. I spent extra time on the section where coffee first hits the container and bounces below because the design I used earlier was clogging after a couple of uses and it was a pain to clean the clogged ground coffees. Also a waste of a lot of coffee. In this design I didn't experience any clogging issues. There is a lot of room for coffee to flow nicely. I made the bottom empty so that I wouldn't have to take out the container every time I need to clean.
Statistics
Likes
19
Downloads
0