Wanhao D6 Magnetic Door Support with Captive Magent Option
Description
This design revision of the design by Monzilla that makes the bracket 2 piece to put the magnets in and then cover them. Use the following thread forming screws or similar #4 thread forming screw for a #37 drill bit: https://www.mcmaster.com/90380a106 In the original design, there are circular sections tucked away underneath the top layer. Unfortunately, they are captive on both sides with no way to insert the magnets, so this design is fundamentally flawed. If fails to offer what the creator intended unless you further drill it or stop your printer mid-print to insert the magnets.
Statistics
Likes
3
Downloads
0