FR7 Straight Arm Edition
Description
This is a slight modification to the FR7 open source FPV frame design to straighten out the arms in the dead cat configuration. This adds minor structural and aesthetic benefits. *Updates May 31st: Options options options! - "no_slots" files remove the slots for holding underslung batteries - "through_hole" components use 6mm oversized inner holes so that the FC stack only attaches to the rear plate, without the bolts touching the arms or front plate. This is the same as the FR7 V4x. Note that the "through_hole" arms and front plate must be used together for this to work. - The standard files treat the FC holes as structural arm fasteners with 3mm holes. The top plate and all 3D printed components are compatible with the FR7 V4. Therefore the SA Edition requires new: - Front arms x2 - Rear arms x2 - Front plate x1 - Rear plate x1 Please see the original FR7 post for a list of hardware: https://www.thingiverse.com/thing:3590777?fbclid=IwAR3W4ZJzAk-u864BvBJYa-K-OUTWq8K3hE4HvLz-c813jqNTNfAPCf_vB-E
Statistics
Likes
16
Downloads
0