Raise3d N1 - Raspberry Pi with 7 inch screen (Controller Replacement)
Description
Instead of paying $450 for a replacment screen and controller from Raise 3d, since I run Astrobox Touch all over my fleet of printers, I went ahead and built out a 7 inch official raspberry pi LCD mount for my Raise3d N1. I may redo the mount a bit to drop the LCD, as it stands you have to remove the from door as the lcd is in the way. I used the lcd case from here: https://www.thingiverse.com/thing:1164446 then built out some back end mounts to be able to mount this into place. I suggest AstroBox Touch (licesnse is $40 / $49 on a flash drive - https://store.astroprint.com/collections/diy-kits-software), and you may need to install drivers for the Raise3d N1 - Arduino. This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/a55T68lQXGZ
Statistics
Likes
4
Downloads
0