Westcott iPoint Orbit Pencil Sharpener cap
Description
My kids lost the cap, so have to print one to keep the messy debris inside. Since I do not have the original cap to measure the dimension, the design was based on the measurement from the body. This electric pencil sharpener(with a power adapter) was bought from Costco couple years ago and should be the same as the Sam's club's model, but not sure if it will fit other battery models (they look alike from the online photos, but don't have one to check). So if you do have a battery power model and it works for you, add your comment to let others know. [Update May 28] I just realized the direction of the groove was reversed in my first print. Since the wall is soft enough to force in, it still fits fine and I didn't notice that until I saw the unexpected mark on the wrong side. The corrected version is now uploaded and you'll need to download again if you downloaded the first day. After printed out the updated one, I felt it is a bit tight, maybe that is because I printed with "Make Overhang Printable" in Cura and that essentially raised the groove starting height a little. So I lowered the groove 1mm and uploaded the file iPointSharpernerCap_1mm.stl. I have not test print the 1mm offset version and not sure if over corrected, since the other one works just fine for me. I'll update the result of it if I have to print one again or if someone makes a comment about it.
Statistics
Likes
2
Downloads
0