Pocket Fletching Jig
Description
This is a pocket fletching jig designed to precisely align standard 2" vanes and have been tested with Bohning Blazer Vanes and NAP Quickspin Vanes – Bone Collector Edition. Use your preferred 2" vanes and adhesive. The supports are press fit into the slots on the front and back pieces. The Upper Supports will only fit into each side one way. Once printed, I recommend test fitting each part, then applying a little glue (I use loctite gel control super glue) to adhere the lower support and upper supports to the front and back pieces. You will need to print: (1) Front (1) Back (1) Lower Support (2) Upper Supports (3) Arms How to use: Place your preferred 2" fletching in each of the 3 arms Apply your preferred adhesive to the fletching, being careful to not get any on the jig components Slide arrow into jig from the front, aligning the notch with the guide at the back Slide the arms with fletching into the guides (arms will only fit one way). Firmly press each arm in place, then wrap with rubber band to hold fletching in position until adhesive is cured based on adhesive manufacturer's recommendation. You can order finished jigs from me at: https://www.etsy.com/shop/krileydesignshop
Statistics
Likes
37
Downloads
0