Himoto Barren bumpers and more (aka Basher Pbull) 1:18
Description
Made some bumpers since the kids where killing these cars because they are so fast :-) Also made some body post, canopy post since those where worn off and some wheel adapters to fit 7 mm wheels with normal holes and not one straight side like the barren wheel axle. Print bumper with a backplate and use M3 bolts or screws (20mm). You can choose to also use some m3 nuts at the back. The high front bumper also has a high support which you can use with 2 short bolts. For the low hole in the bumper use the original screw from the car. I also use some tyraps for extra support on the high bumper and that will also hold the double canopy holder. Bumpers an be printed on 0.3 mm and infill 60 % if you want. Printed mine infill 100 %. You may also use some hotglue behind the bumper to make sure it realy doesn't come off. The body post are part off the upperdeck and to replace them you need a complete new upperdeck. Now with my design you don't :-) The canopy will be a little higher at the front but it will not come off. I recommend you print all part with flex accept for the 7mm wheel nuts ( wheel adapters) I made some in different hights and you may have to increase or decrease size by 1-2 % depending on material and shrinkage. These adapters fit the shaft with the flat side so you can use other wheels with 7mm nut hole. With these adapters you can use these wheels A959 Wltoys : https://www.banggood.com/Wltoys-A959-RC-Car-Spare-Parts-Wheels-A95901-p-928687.html?rmmds=myorder&cur_warehouse=CN
Statistics
Likes
7
Downloads
0