Anet A8 bed connector strain relief
Description
Made a variation from ozfunghi's V1 strain relief to avoid stress in hotbed cable connection due to continuous movement. This design is also easy to install but stronger. Can be used both with original connector and also with directly soldered cables to the bed (as is my case). As you may know this is one of the weakest point in A8 printers and this kind of improvement is mandatory. You can hold the cable with a cable tie. No support needed. The spring goes inside the hollow.I also include two spacers for the front screws of the bed to balance the height.
Statistics
Likes
7
Downloads
0