SafariLand 578 pro holster spacer
Description
This is used to get the safariland 578 pro holster away from the direct to belt mount and make your pistol much easier to draw. I used nylon spacers for mine because i already had them, but this will achieve the same effect. print 2 of the 25mm ones for the top, and one of the 20mm ones for the bottom. The countersunk part faces the holster. You will also need 3x #8-32 x2" screws and washers for said screws (for this specific holster). install and mark, then chop off the screws. Blue loctite to finish. Print standing up
Statistics
Likes
1
Downloads
0