Roland V1-HD video switcher mounting bracket
Description
This is a quick bracket design we made to mount the unit on a stand , the holes will accept a 1/4 bolt easily , the rest of the assembly was made with a 1 foot in length flat bar , holes drilled aprox 1/4 inch from the end with a 3/8th's bit ( use between 9/32 and 5/16) then using a vice or equivalent clamp flat bar aprox 1/2 in towards the center of the flat bar from the drilled holes and mark a line , then bend the drilled ends 90 degrees to create the flange seen in the photos. the best distance (measured from inside bracket to inside bracket is 10 1/4 inches ) so after bent the metal flat bar shouldn't be wider than 10 1/4 inches (flat bar measured outside to outside) Roland V1-HD video switcher mounting bracket
Statistics
Likes
0
Downloads
0