Ender-3 MKSV1.4PI3B+
Description
Ok spent about 9 hours looking for that perfect box for the MKS board and Pi and nothing of interest but I happened upon this box and it's just what I was looking for so I Hacked away on it till it had what I wanted. Now it holds MKSV1.4 board and Pi 3 B+ as well as 2 slots for 2 single relays that just slide and lock-in. Also, I included some small pins you could glue to the inner board bottom to fit whatever you need board wise. I cut openings for the pi and extended the original carrier board. Along the back, I have included a mount for BIQU Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer . The front is for addon 12864 LCD Graphic Smart Display. I chopped PSU off and left the bottom open for easy printing left the screws and lid alone love that design. Include a button for a reset for display not sure if it's scaled right. Imprinting this now not sure how accurate it is but I'm thinking I will be really close. Ok so in Hour 16 so far at 50% I would say the only real issue is the bottom pulling up from the edges so I think the wise thing would be to put down a raft if you're going to print this. At first, I thought the best way would have been top-down but now I'm glad I didn't. it would have been disastrous. I was able to hot glue it down before any real dmg happened and repair fallen supports. If all goes well ill drop it in the oven on 100 for an hour to correct the bottom. No matter what happens at this point i can salvage and make it work. (I hope) So at layer 252 it started to stray so im stopping there and splitting printing top not will glue them together.
Statistics
Likes
17
Downloads
0