Gear switch arm
Description
On My 20HP J-725HP ohnson outboard engine The gearnswitch srm was broken. This arm is only available as a complete part. steel rod with heat shrinked plastic T-Split. AsnIP'm a bit lazy I didn't want to remove the complete engine to just replace this plastic part that is on the outside so I just created a new plastic part with extremly tight fit. Heat up the rod anfewnsec then press on the new printed part and the gear switch arm is as good as new. There i two versions, one as original which has to be pressed on, second version is clamp version witch need a M6 screw and nut. (use this one if you don't have possibilites to heat the steel axle) If you like what I'm doing, please consider supporting me https://www.buymeacoffee.com/taguvove
Statistics
Likes
4
Downloads
0