JDFPV HOVERCRAFT
Description
Finally Getting A Chance To Share My Hovercraft Design Super Fun Project that i hope Everyone Enjoys. Video above to give details on this Setup. https://youtu.be/C-BwKlPX_bk All that is needed is: 1 - 9 gram servo 2 - esc 20 to 30 amps 1 - 1306 motor 1 - 1806 motor 2 - heavy duty paper clips or heavy gauge wire 1 - RX 1- 5v bec 17-20 hours worth of printing The main body took about 13 hours to print with supports. Rear motor mount needs supports as well. Base requires no supports. Note: Set Limits on the servo. If not when you turn too sharp it will allow the rear motor prop to cut into the bag. Enjoy! Any questions please hit me up on Youtube or My Facebook Page. Also if anyone wants to use a bigger motor on the inflation please message me and i will add a redesign just for you. FYI. I have never tested this on water... Only in my driveway and on hardwood floors. https://youtu.be/u3MOLA6lsk4 https://youtu.be/azq7CFM1olk https://youtu.be/IwFPzk5yRcE
Statistics
Likes
15
Downloads
0