Caliburn barrel covering the threaded rods
Description
Designed multiple caliburn barrels that hide the threaded rods. It replaces the plate that hides the hex nuts. It is a friction fit for me but you can add a screw on the bottom if needed, just drill a small hole in the connecting plate and you can screw it on. When using the longer barrels make sure that your inner (metal) barrel is also that long, it won't work without an actual inner barrel. short version: 83,5mm medium 'cutoff' version: 130,87mm long straigth version: 132,68mm If you are looking for a really long version you can use my building block version here https://www.thingiverse.com/thing:3685439 The version without the actual barrel is made for inserting a 25mm (alu) tube and thus make a much longer barrel without hindering performance, more info can be found here: https://www.thingiverse.com/thing:3685495 But this version can also be used without adding a barrel inside, it is designed so that it won't hinder your dart with or without a barrel. Can be printed without supports, you will only need to remove some messy filament in the hex nut holes. The picture is from a test version for a longer barrel base, it still has holes in the side to fix the barrel and no cutoff at the end. All rights for captain slug since it all a remix of his original design.
Statistics
Likes
37
Downloads
0