Chain_Chomp_Switch_Cartridge_Stand
Description
This is a stand for my previous "Chain Chomp Switch Cartridge Holder" design. |Materials Needed| 1) super glue 2) acrylic paint (if wanted to paint) 3) sand paper (for smoothing of support material, if needed) |Printing Instructions| 1) Print the "Base_CC_Stand" file at 10% infill density (print speed was a 50 mm/sec). 2) Print the "Base_Link_CC_Stand" at 25% infill density (print speed was a 25 mm/sec).. 3) Print the "Post_CC_Stand" at 25% infill density (print speed was a 40 mm/sec).. 4) Print 12 of the "Link_Halve_CC_Stand"'s at 25% infill density (print speed was a 25 mm/sec). |Assembly| 1) Do all PAINTING and SANDING and make sure the post fits in the pilot hole of the base. --> Base: Green --> Chain Links: Silver --> Post: Brown 2) Super glue the Chain Link Halves, one by one, starting at the chain link connected to the Post. Should have 6 interlocking chain links connected to the post. 3) Slip the end of the chain on to the "Base_Link" and then super glue it into the Base.
Statistics
Likes
6
Downloads
0