101Hero rail bushing slop reducing clamp
Description
This is a simple clamp that clips round the rail bushings on a 101Hero Pylon printer. There is some slop in the stock bushings and i made these to reduce said slop by having them hold a little tighter to the rails. Be sure that they slide freely on the rails but are not loose, you can file them a little if they are too tight. grease them and clip them over the existing bushings (2 per rail pair). you will need to print 6 in total. double check that they all slide freely on the rails at the same rate to avoid uneven travel. printed in PLA, 0.2mm layer hight. 30% infill with raft. no support needed. orient the part to print laying on its back.
Statistics
Likes
1
Downloads
0