Simple plume sprinkler / Water blaster (print in place)
Description
This is a simple "Plume" sprinkler / myster / water blaster thingie, based on the great design ["Noch ein Regner"](https://www.thingiverse.com/thing:3068655) by 3DPNoob, but redesigned to print in one piece (no assembly), with the Gardena connector from the ["Pilzregner"](https://www.thingiverse.com/thing:2996712), which workd well for me. Gives nice coverage even at low pressure, more of a mist than droplets. Can be used as a hand watering tool too, or even as a "crazy blaster" by putting it on the end of a piece of hose (maybe someone remembers that toy from the 80s..) [Check out the video to see it in action](https://youtu.be/61ljK4m30XE) :-) The model has some tricks to fools slicers into doing the right thing, so the **maximum layer height I'd recommend is 0.24mm**. Tested in Cura and Slic3r Prusa, **if using Cura, uncheck "Ignore small Z gaps".** For PLA, I found it needs at least 3 or 4 perimeters, otherwise it leaks between the layers. Should be printed **without** supports. There's two versions, one with the Gardena type connector, **for which you'll need an O ring** which you can scavenge off a Gardena fitting or buy. **The other version has a 3/4 British thread** (not tested yet..).
Statistics
Likes
112
Downloads
0