Catalyst Machineworks Raging Droner Antenna Mount
Description
This is an antenna block for the Catalyst Machineworks Raging Droner. Designed as a replacement for the stock antenna block as well as a version to fit my Fin design for the Raging droner. The 7.5mm version is the factory distance to fit Catalyst Machineworks stock 3D printed accessories. The 6.0mm version fits my Fin design. Also upgraded the antenna holding design. IMPORTANT! Insert the Catalyst Machineworks antenna tubes before installing the block to the carbon fiber. The metal screws are an interference fit with the antenna tubes. The tight fit for the tubes is intentionally designed to work with the tubes provided by CM. If you are having a hard time inserting the tubes, hold the TPU printed antenna block in your hand until it is warm. The tubes should fit snugly. The tubes will NOT go all the way through towards the front. I print with SainSmart TPU at 20% infill and 3 walls. Do not print supports for the antenna tube holes or the sheet metal screw holes.
Statistics
Likes
7
Downloads
0