PhotonstersStamp Printed on AnyCubic Photon
Description
Making Rubber stamp with Anycubic Photon. Here are the settings I used to make rubber stamp using the Anycubic Photon. Resin Composition 65% Monocure 3D Rapid FLEX100 + 35% Monocure Rapid 3D Black. Higher percentage of Flex will make the thin features curl up due to internal stress ChiTuBox Settings Z Lift - 0mm (Lay flat on the build Plate, Big thanks to Johnson Yeh for the suggestion) Raft shape - None Support - None Support Density - Not applicable Print Settings Layer Height - 0.02mm Bottom Layer count - 8 Bottom Layer Exposure - 60Sec Exposure Time - 7.5 Sec Bottom Off Delay - 6.5Sec AA Settings - I tried it with and without. Didn't see any difference at all. Color Box ink pad worked the best for the stamps I made using the Photon. Below is the Amazon link for the ink Pad https://amzn.to/2ZojrG0 The stamp is 30mm in diameter and the lettering are quite small. Photon was able to print it perfectly including the 'period' for the '.org'. See the attached microscope images. All the features in the stamp are extruded to 1.25mm. It take about 40 minutes to print this at 20um resolution. I believe the Z steps can be increased to cut down the total print time but I have not experimented with it. The stamp Handle was made using FDM with ABS (No particular reason. I just had that loaded in the FDM printer at that time)
Statistics
Likes
27
Downloads
0