1.0" 8 Hole R/C Wheel
Description
PLEASE NOTE: If the wheel ends up being scaled to 10,000% in your slicer, try re-scaling it to 2,540% for the correct size. This is a simple 1-piece wheel with a classic 8-hole design for micro rock crawlers. It is designed to fit RC4WD 1.0" tires. It has a 7mm hex and a 2.5mm axle hole. It has scale lug nuts that I colored silver with a permanent marker. It has more negative offset (making the track width wider) than the stock wheels on the ECX Barrage and Axial SCX24 (see pictures for width). You can glue the tires to the wheels, but I decided not to as they stay on pretty well unglued. The M8 washer version is designed to hold 2 M8 washers (with an 18.75mm OD) for added weight. They also double as scale brake rotors! These wheels slightly have less offset in order to fit the washers. The area around the hex is also thicker to make it easier to glue the washers on. There are tabs on the inside of the wheel to help center the washers. Please note that you may need to file the wheel hexes on your truck in order to get them to fit through the washer and into the wheel hex. Also, you might not be able to fit two washers depending on your truck. UPDATE 6/22/19: I made the tolerances on the washer version tighter to center the washers better. After printing the wheel I noticed the washer was a little too loose. UPDATE 6/22/2020: Made a modified "Scrambler" version that is optimized to fit RC4WD Scrambler tires.
Statistics
Likes
88
Downloads
0