Craftsman 113 Throat Plate Insertinator - Zero Clearance
Description
This is my zero clearance throat plate with splitter hole. I made this for my 1950's era Craftsman table saw model #113.27521. It is approx 3.75" x 14.375" (95mm x 365mm). This is my third go-a-round. My first version was just a single 2.4mm thick part, but in petg, was way too flimsy and ended up shattering while cutting small stock. The downward force from the push stick was too much and it broke, sending my push stick into the saw blade kinda hard, which shoved the push stick into my hand giving me a small owie. Lesson learned... Version two had the bottom side thickened way up, but it warped a bit, and was a bit too thick so it didn't sit flush with the table. Other than that it was good. This version refines the underside features a bit to save on filament and print time. It fits perfectly flush with the table.
Statistics
Likes
38
Downloads
0