Mods for Anet A8 E3D V6 Modular Carriage
Description
I redid a few parts in my recent bowden conversion: * The BLTouch mount was set up so that the sensor drops through from the top and is secured with just a couple of M3x6 screws. Basically, it's a fixed mount. Start with the Z-axis offset at -1.00 mm and tweak it from there. * The nut traps in the base plate are a bit oversize. I shrunk them for a snug fit so that they shouldn't fall out. * The block that holds the extruder in place was modified for better compatibility with the cable chain I already had. * I don't like fan ducts that obstruct access to the hotend from the front, so I moved the blower over to the left. The fan duct bolts to the left side of the baseplate so that it can't fall onto your print; the blower slots into it from the top and is held in by gravity. (I had another blower in here previously, but I suspect it wasn't letting enough air through, which made printing some overhangs problematic.)
Statistics
Likes
5
Downloads
0