Magnetic Light-Ring for Dremel 220 Workstation
Description
<p>Just few days ago, I published another version of the <a href="https://www.thingiverse.com/thing:3700665">Light-Ring for Dremel 220</a>. In that occasion, I suggested to upgrade by use of magnets. When I came up with the idea, I couldn't resist. So, I did it by myself. :p</p> <p>With respect to the older version, you'll find following changes:<ul> <li>Magnets on the back side of the <i>holder outer.stl</i>.</li> <li>Additional STL to be printed (</i>magnet holder.stl</i>). It is necessary to properly fix opposite magnets on Dremel Worstation (around the locknut).</li> <li>In this case, LEDs are flush with <i>holder outer.stl</i> component. This change was necessary since LEDs can obstruct the tightening of tools into Dremel.</li> <li>This is absolutely cooler then previous one :P</li></ul></p> <p>As magnets, I used 6 neodymium magnets with sizes 5x10x1mm.<br>Note: <u>pay attention to magnetic polarity before fixing everything!</u></p> <p><i>Enjoy</i> :)</p> https://youtu.be/WI6uVrklOHY
Statistics
Likes
6
Downloads
0