P802 Main Mounting Bracket for Quick Swap
Description
Accompanies this set of Quick Change mounts: https://www.thingiverse.com/thing:2750693 Print as viewed in the Thingiverse photo for fastest time and no need for supports. I've created a version of the main Mounting Bracket that will work with a TronXY P802, as the distance between the two X-Axis rods is slightly smaller than on the Anet A8. Other slight differences are the width of the C-shape needed to be altered, a small bit of the bottom needed to be reshaped to accommodate for a screw, and I made the holes on the back go all of the way through. As for the extruder carriage bracket itself, I had to use a Dremel to carve out a small section on both sides (where the C-shape slides into the carriage bracket), and I had to completely remove the belt tabs. On the Anet A8, the X-Axis belt is held by screws, but on the TronXY P802, there are tabs on the carriage bracket. So I Dremeled those off. The revised bracket works great with my P802. To get the accessory mounts to slide in, I did have to sand down their edges slightly, but I attribute this to my printing resolution, and not the files themselves.
Statistics
Likes
7
Downloads
0