Pi Camera V2.1 Housing
Description
I noticed a lot of the pi cam mounts on here required pretty tight printing tolerances in order to mount the board and attach the ribbon cable successfully and I just wasn't having any success producing them on my Ender 3. This model provides a decent amount of clearance around the perimeter of the camera board and the camera itself as well as a wide opening for the ribbon cable to extend out of. Note that the Pi Camera 2.1 mounting holes are 2mm in diameter but I only have M2.5 raspberry pi mounting screws so I just enlarged the mounting holes (CAREFULLY) using a 3/32 drill bit (if you have a metric bit that would probably be better lol). Note: I didn't include any external mounting structure since I'm not sure yet how I'm going to mount my camera to my printer, but you could easily put a square of double-sided tape on the back. If there is interest I may add an update to the model with some kind of mounting geometry. My Assembly Parts List: - Pi Camera V2.1 - Housing Front and Back Parts - M3x8mm Screws (2x for joining the two halves) - M2.5x4mm Screws (4x for securing the camera board https://www.amazon.com/gp/product/B0756TBY2R)
Statistics
Likes
23
Downloads
0