Prusa i3 Mosquito X Carriage
Description
I created this X carriage for Prusa i3 Rework X-carriage (https://www.thingiverse.com/thing:586636). The main goal was simplicity, compactness, sturdiness, support for E3DV6, drag chain, inductive sensor and lighting. All this was achieved however my lighting solution has its flaws as this was an experiment - I modded Prusa fan duct to accomodate led strip if you are going to add it be sure to have the hotend cartridge isolated as it may touch with the led strip and short. I am not responsible for any damage this may cause. Print in ABS or PETG or other good temparature resistant filament. Use only with silicone heat block sock! To attach this X carriage use self tapping screws. Use self tapping screw to attach hot-end as well. I use 18mm inductive sensor. Chain used: https://www.thingiverse.com/thing:1872473 If you like my design, like this, follow me, tip me or check out my other designs. Cheers!
Statistics
Likes
3
Downloads
0