Raspberry Pi 3.5" piTFT
Description
Remixed from [this thing](https://www.thingiverse.com/thing:3602609) Inset 3.5" adafruit 2441 piTFT with risers printed. I print the base vertical with a brim and supports everywhere. <b>Warning!!</b> <strike>the standoffs for the pitft are a bit short, put in a washer or couple tiny o-rings between the standoff and the pitft screen.</strike> the pitft may crack on tightening <strike>if you don't put something in that space</strike> there was a little bugger of material on the backside that upon tightening the screen cracked on me
Statistics
Likes
53
Downloads
0