Intex Hose 1.25 to 1.5 Adapter
Description
This adapter allows joining a large Intex 1.5" hose to a small Intex 1.25" hose. The large end needs an Intex gasket and the small end needs an O-ring. The small end is a bit low poly, but adding some teflon tape fixed that. The large end was difficult to screw on, but soaking it in boiling water for 5 minutes shrunk it enough to screw on/off easily. _____ Update 1 - Another user has suggested for PETG soaking in boiling water for 2 minutes yields the exact size Update 2 - I've found scaling the model on X and Y (but not Z) by 0.5mm also produces a good fit
Statistics
Likes
28
Downloads
0