86mm*16 oil filter cap remover 1/2" squre socket
Description
This is an easy to print oil filter cap remover, designed by myself, for my Volvo V40. It worked succesfully, but you have to make it with 100% infill at the bottom section, because I done it with a 40% cubic infill with PLA, and the 1/2" square hole deformed quite well at 25Nm of torque. (25Nm is the spec torque for the oil filter cap) The uploaded mesh file is an upgraded version with better toleraces and ribs, so you can grab onto with your bare hands as well. The 4 hole at the bottom is just for some material saving, and you can also see what's going on in the socket.
Statistics
Likes
8
Downloads
0