Prusa i3 MK2x - Heat Bed Cover (60 Degree)
Description
This is a redesign of OakMountain's "60 degree heatbed cable cover" thing, it has been rehashed for the heatbeds with bolt-on connectors, instead of soldered wires. The design provides enough room for the plastic crimp/strain relief cups, and provides a nice snug hold of the cable wrap (textile fabric). NOTE: It should also work with the plastic cable wrap, but i would be interested in feedback. Lastly, on the opposite side of the two bolt cable hole, there is a small wedge "catch" to hold the two pieces snug against the PCB heat bed. # Important There is a single-layer skin over each bolt/nut hole, so that proper bridging is done. Using a drill bit, you can easily poke through the "bridging" and open up the hole for a bolt.
Statistics
Likes
9
Downloads
0