Samsung Galaxy S9+ (S9 Plus) Case
Description
Phone Case to fit the Galaxy S9+ with a pretty cool pattern. 3D Printed with an EOS P396 SLS machine in PA12 Nylon. There are 3 CAD files included: - Rev 2 was slightly too lose when I printed it. There is also an extra hole that is not needed. - Rev 3.1 has a 0.3mm offset to make the phone sit tighter in the length. This print has not been tested. The extra hole is plugged up. - Rev 3.2 has the same 0.3mm offset plus an additional 0.15 offset in the width to make it slightly tighter in its width. The extra hole is, again, plugged up. This design is currently printing. The pattern was designed by Xrontos and used in his Honor Phone case: https://www.thingiverse.com/thing:3537674 The creation of the case was a bit of a bodge and is detailed in greater detail in the design section.
Statistics
Likes
174
Downloads
0