Two Trees Sapphire Mount E3Dv6 Version 2
Description
Version 1 with 5mm offset y-axis - Fan 30-40 mm Version 2 Fan 30-40 mm (can bump into top belt bearing so you have to extend x-axis stopper with 2mm) Version 3 Fan 30 mm only (+ extra z height) Here is version 2 of the mount for E3DV6. Placed the hot-end 5mm to the back so no loss in Y-axis anymore. For some printers the fan is bumping into the left belt bearing before reaching the X axis stopper. Print the 6/8 stopper to extend the stopper of the printer with 2mm. Mount print with support in Cura put on Enable Support Brim for better stick to bed of very small supports. Ducts can be printed without support laying flat on the bed. You need 2x M4 hex screw, 18mm to mount the front. To mount the hotend to the printer you can turn the current M4 screws and screw into the model. It can be wise to use inserts for longer fit but I didn't have issues yet. Link to one of the 40 mm adapter fan. I did not test 40mm fan but there is space. https://www.thingiverse.com/thing:3322583
Statistics
Likes
14
Downloads
0