Ender 2 filament bracket (E motor) relocation guide with added pressure feed helper to prevent filament rubbing on Z-axis rod
Description
A remix of "Hitchabout's" Creality extruder relocating bracket. This fits the Enders original filament feeder/mounter mount. Improvement =========== - I found that Hitchabouts filament guide post on the re-locator was a few mm's away from where mine needed to be, so I moved it. - I've added a second post with a handle, that can be screwed in or out to push the handle of the extruder device in, which makes it way easier to feed in filament without trying to hold the springed handle in (it could also possiby be used to help restrict the amount of pinch the gripper gives to softer material, like TPU). Tips ==== Drilling out the hole in the original post/guide will allow another bowden tube to be used on the input side. Mine held in pace quite well, but might need a cable tie or a little bit of hot glue to hold it in place for others. The handle is a tight fit on the bolt I used, so might need a tap with a hammer to get it in correctly. The toothed brass fitting on the original extruder device will need to be flipped over 180 degrees with this bracket (mine or Hitchabouts) as the motor is deeper than using the Enders, which means there is no extra motor shaft left to add a handle (used to turn the motor manually when feeding in new filament) which is good reason to use the remixed version I have here.
Statistics
Likes
2
Downloads
0