Dna 200/250 Power Supply Mod Pod
Description
This model is part of a few models mostly vape related I'm releasing to the public from my data vaults most are a few years old and some are mostly just usable as assets, check my profile for other designs that may be of interest in the next few days. If you appreciate the designs I upload please consider leaving a tip via thingiverse. A lot of time goes into some of my designs, and a lot more goes into the designs that never quite made it to thingiverse. So this ones actually kinda awesome, the idea was to make a dna200/250 mod as small as possible, and the best way to make it even smaller is to relocated the power source. In this case I have a 12v atx power supply that sends 12v to up to 4 mods via the quick disconnect connections. Parts List: 1x Dna 200/250 1x Speak on quick connector 1x 510 Misc wire and wire shielding Print is incredibly straight forward here, the face place prints flat side down and the rear pod prints vertically. The 510 connection is located so close the chip when wiring you just bend the group tab on the 510 90* and solder it directly to the chip and run a positive wire like normal. Wire in the speakon connector to the power input and you have two wire channels to run the main power wire out of depending on if you want the mod to sit flat or not. The two halves just slide together for a nice friction fit.
Statistics
Likes
10
Downloads
0