Cetus Y axis endstop holder
Description
If you are updating Cetus mk2 CPU to TinyFab CPU, you need to [get the end stops](https://www.tinyfab.xyz/product-page/cetus-mk2-to-mk1-downgrade-end-stops-pack-of-3), and add them to your printer.The end stop holder provided by Tinyfab conflicts with the default mk2 Y cable holder. I merged both into a single part, and made it look minimal. It also has slots for the end stop wire, which you can then route inside the Y cable so it looks nicer. (i.e. cut open the heat shrink at both ends, run the end stop wire through the nylon sheath and add the heat shrink back.)
Statistics
Likes
1
Downloads
0