Emergency Push Rods and Control Horns - L'Hélice Cassée
Description
Hi ! During our last RC challenge my brother and I were short of push rods and control horns so we made an emergency kit ! You don't even need to get screws ;) It contains : - 8 mm push rod - 12 mm push rod - 8mm 90° angle push rod - 12 mm 90° angle push rod - Control horn - a clip for the control horn How it works ? Well, usually when you open a new servo, you get a least 3 screws : 1 small for the little lever of the servo and two bigger one to fix the servo. We'll use the biggest one to fix the push rod on the control horns. Use a drill bit to open a little more the push rod holes if needed. I has to be able to turn freely but we don't want it too loose. Next, just screw it in the control horns and you are done ! ;) With those you should be able to get most of your DIY things working ;) We do recommend printing these with solid filament, 100% infill and a lot of perimeters. - Watch the video were we used them : https://www.youtube.com/watch?v=7SEwEP6Y_CY&t=1s All our 3D designs are free to download ! Want to support us ? --> Download the Hélice Cassée Helper's KeyRing here : https://cults3d.com/fr/mod%C3%A8le-3d/gadget/l-helice-cassee-helper-s-key-ring --> Get a sticker : https://www.etsy.com/fr/shop/LHeliceCasseeCie --> Become a Patreon : https://www.patreon.com/join/helicecassee? --> Visit our Facebook page : https://www.facebook.com/helicecassee --> Check out our youtube channel : https://www.youtube.com/channel/UC-Dr9j7lASkgQ8-8uTPTLEw
Statistics
Likes
2
Downloads
0