Ender 3 Dual Z Axis with Meanwell LRS-350-24
Description
EDIT 7/11/19 I changed the mounting, making it easier to slide into the extrusion, my apologies for those who had issues. No extra hardware needed Print: Fatter side face down, where the switch would mount, with support. I did zig zag support at 8% and it worked very well Upgraded to dual Z motors using a comgrow CR-10 kit on my Ender 3, needed a PSU mount and wanted a simple one. This should just slide into the extrusion and mount to PSU with two bolts on the tallest side wall. Please let me know how the fitment is so I can make adjustments if needed. Some helpful tips from user made_man: https://www.thingiverse.com/made_man/designs Some tips for slicing this with Cura: This can be printed without any supports. Set Infill Overhang Angle to 0, otherwise some parts may not have any infill. Set Z Seam Alignment to a user specified corner, away from the rails. Set Initial Layer Horizontal Expansion, if you are worried about slight mushrooming on the first layer that could block the rails. (I used -0.3)
Statistics
Likes
45
Downloads
0