D6/MMU cable clip head cap with push-fit connector
Description
A couple years ago, Hlanderd had the neat idea of fitting the head with a pneumatic cable connector. I found this useful, too, as if the filament is a little bent, it might not go straight down the hole below the PTFE tube. When this happens, pushing on the filament just makes the PTFE tube pop out, then I have to take the cover off... kind of a pain. Nothing was posted back after that suggestion/request, so I figured I'd have a go. _Edit: I wasn't thinking things "through!"_ This design is a little silly because after you get the filament past this fitting, it has to go down through another tube. I revised this design to make a push-through version that lets you take the PTFE down through the bracket all the way to the idler arm. See remix, https://www.thingiverse.com/thing:3749924
Statistics
Likes
3
Downloads
0