Wanhao Duplicator 6 D6 - Monoprice Ultimate Maker - Rear Holder for run-out sensor, ribbon cable, filament filter, tube and pulley
Description
Print: 1 Total Rear Holder 1 Adapter spacer 6x8mm 2 Filter Filament 2 Conical Pulley The flat washer is only necessary if the M6 bolt has a head that tends to fit the bearing and it is necessary to distance it. The spacer adapter must be positioned between the pulley and the Total rear holder. To complete the project you need: - nr. 03 Magnets 20x6x1,5mm (https://www.amazon.it/dp/B00382J9UO/ref=cm_sw_em_r_mt_dp_U_wpLgDbVPXPR1R) - nr. 01 bolt with nut M6x20mm (https://www.amazon.it/dp/B07NGHSDT7/ref=cm_sw_em_r_mt_dp_U_BqLgDbJMZZV91) - nr. 02 bolts with nut M3x20mm (https://www.amazon.it/dp/B073SS7D8J/ref=cm_sw_em_r_mt_dp_U_dxLgDb8F5EY9N) - nr. 01 ball bearing 608 (https://www.amazon.it/dp/B071W18NQN/ref=cm_sw_em_r_mt_dp_U_CzLgDb46P32KW) - nr. 01 run-out sensor micro switch ( https://www.amazon.it/dp/B07FSXFPLD/ref=cm_sw_em_r_mt_dp_U_ZALgDbDWR4CFG) The run-out sensor holes are slightly wider to allow perfect centering with the upper hole and also with the filament tube. The support attaches to the printer via the snap clips in the rectangular aperture, making it more stable with two small strips of double-sided tape. The magnets are removable if the orientation is wrong, once you find the correct housing we recommend putting a small drop of Loctite Attak (cyanoacrylate glue). The two parts of the pulley fit together using the ball bearing, but even here two drops of Loctite Attak block everything. The links shown are only to understand what it is, you don't need to buy those.
Statistics
Likes
8
Downloads
0