SCW BMX/Moto Style Grips
Description
Strathcona Cycle Works. BMX/ MTB/ E-Bike/ Cruiser Beta Grips. These need to be printed very slowly with a direct extruder, on a heated, or painters tape covered bed, with the Jerk turned down. The flanges kind of act like rafts, but you may want to use them with the flangeless grips, and remove after printing. You may have to scale them down slightly depending on the elasticity of the filament, so they won't slide off the handle bar. And if you don't already have bar end plugs, I'd suggest popping a nickel into the end of each grip to prevent the bar from cutting though if the bike falls over/ is crashed / etc.
Statistics
Likes
23
Downloads
0