Feelfree kayak cam lock / toggle
Description
So, like a dumbass I unknowingly over tightened the screws on my feelfree kayak sonar pod cam locks. sure enough, 4 sessions later one broke and my mistake was revealed. unfortunately this is all too easy to do so I imagine I'm not the only person to have fallen foul of this. this is a direct replacement for the cam lock, just print, clean up and bolt in. print in orientation provided, I printed in ABS and acetone smoothed to finish, other materials should work just as good though. my print settings: ext: 240c bed: 110c speed: 40/30mm/s lay H: 0.2mm infill: 100% supports: yes (PLA might be fine without, your choice)
Statistics
Likes
7
Downloads
0