Ciclop Booster Seat
Description
I found my NEMA 17 stepper motor was about 12.5 mm taller than it's chamber in the BQ motor holder - AFTER spending a cuple of days printing. What to do? Taking inspiration from little kids in restaurants, a Ciclop booster chair was born. Simple 4-blocks joined by rails, with edge-guards to trap the Ciclop onto it - one for the motor holder, and, to keep them on the same level, one for the camera holder. I could have run rails to connect the two units, but was lazy. Besides: a few dribbles of super glue, and these quickly become one with each... This will provide 20mm boost - more than enough for my motor, and likely yours, too.
Statistics
Likes
0
Downloads
0